Skip to main content

Doepfer A-184-1 RM/S&H/T&H/Slew Limiter Vintage Version - Discontinued!!!


Module A-184-1 is the combination of three functions: 

  • Ring Modulator
  • Sample&Hold/Track&Hold unit
  • Slew Limiter

The same functions are actually already available in other modules (e.g. A-114, A-148, A-170). But in many systems it's not necessary to have two ring modulators (A-114) or two S&H units (A-148) or two slew limiters (A-170) available. That's why we have compiled these function in one small 4 HP module.

The upper section is nothing but half of an A-114, i.e. a ring modulator with the usual X/Y inputs and the X*Y output. Inputs and outputs of this sub-unit are AC coupled, i.e. suitable only for audio signals. A detailed explanation of a ring modulator can be found on the A-114 info page. 

The lower section is the combination of a Sample & Hold (S&H) / Track & Hold (T&H) unit and a Slew Limiter. The S&H/T&H unit is identical to one half of the module A-148. The slew limiter is the same as the upper section the A-170. The S&H/T&H unit and the slew limiter are internally connected and cannot be used separately.
A toggle switch is used to set the mode to S&H or T&H. In S&H mode the unit picks out a sample from the voltage at the SH input at the rising edge of the trigger signal input. In T&H mode the output follows the input voltage as long as the level of the trigger signal is high. As soon as the trigger signal turns low, the last voltage is stored. The trigger input is internally normalled to high, i.e. the unit works just as a slew limiter in T&H mode when no trigger signal is applied.

Detailed explanations of S&H/T&H and slew limiters can be found on the info pages of the modules A-148 and A-170.

Technical notes:

  • required min. trigger signal level: +5V
  • The S&H/T&H function is realized by pure analog circuitry (electronic switch followed by a holding capacitor and buffer). Consequently the output voltage drifts a bit in the holding state because the capacitor is discharged by parasitic resistors. The typical drift we measured is about 30 mV/minute and depends also upon environmental conditions like humidity or temperature. For the storage of control voltages over a long time used to control the pitch of a VCO the module is suitable to only a limited extent.
  • The S&H/T&H unit and the slew limiter are internally connected, i.e. they cannot be used separately. If only the S&H/T&H unit is required the Slew Time control has to be turned fully CCW. If only the slew limiter is required the switch has to be in position TH and the Trig In socket has to be left unconnected. With these settings the S&H/T&H unit is bypassed. 
  • The S&H/T&H/Slew Limiter unit is not suitable for the processing of audio signals but only for slowly changen signals in sub-audio range (e.g LFO, envelope, random voltage).

120€

Power consumption: 40mA at +12V and 30mA at -12V

Depth: 40mm


4 HP

Choose your Language


Alex4

Alex4 Distribution GmbH
Lessingstr. 98, 100 – Haus 11
13158 Berlin
Germany

This email address is being protected from spambots. You need JavaScript enabled to view it.
www.alex4.de

Tel +49(0)30 - 61 65 100 40
Fax +49(0)30 - 61 65 100 49


Cookie Consent

By continuing to browse or by clicking 'Accept', you agree to the storing of cookies on your device to enhance your site experience and for analytical purposes.